Source Metals
FAQ

FAQ

Can’t find what you’re looking for?

We have shared some of our Frequently Asked Questions to help you out!

Other Services (5)

Category: Other Services

Our machine can bend and form up to 1″ thick material and 144″ long.

Category: Other Services

Bending and forming is taking the flat sheet of material and putting it in a machine to bend it at a 90 degree angle or form it at a couple of different angles.

Category: Other Services

Edge beveling is taking the material and putting it through a machine to take some of the material off the edge and make a bevel on the flat plate. We then usually take the beveled pieces and weld the two parts together. This makes the material fit better.

Category: Other Services

Plate rolling is taking the flat material and putting it in a machine to roll it into a circle. We can only roll up to 1/4 in material and 49 in wide.

Category: Other Services

The simple machine service that Source Metals provides is putting a tap thread or drill a hole in the flat plate.

Still have a question we have not answered? Email us below.

error

Find us on Social Media!